Throttle Body Kit

Our Throttle Bodies come fully assembled and ready to bolt directly to the Cylinder Heads, with the following parts included:

• Aerospace grade billet aluminium “shaft-less” individual throttle bodies

• Aluminium inlets/extensions are suitable for duck or whale tail models

• Optional 3D Printed custom curved Inlets/Extension available to allow for bonnet clearance around the standard 964 electronic spoilers

• Aluminium ram pipes

• Throttle position sensor (TPS)

• Billet aluminium fuel rails

• Thermal insulation gaskets

• Throttle linkage system which connects directly to the existing OEM cable pick-ups

• Available with 42mm or 44mm Inlet Ports

We have also listed the supporting parts that create this full plug & play kit:

• Emerald3D K6 ECU including base map package - Comes complete with all electrical harnesses, hardware and software

• Fuelling system - includes fuel Injectors, fuel pressure regulator with gauge, fuel lines, fittings and hoses to interface with existing fuel system

• Vacuum system - includes vacuum block, non-return valves and associated interfacing pipework for brake boost assistance

• Engine oil breather system - Includes all filters and interfacing components required

• Megaflow air filtration system - includes Megaflow air filters complete with brushed aluminium pre-drilled Filter back plates

• Heater duct system

Due to the removal of existing OEM parts and the introduction of light weight billet aluminium parts, we have found a reduction in weight of 10.5 kilos.

Also available with drive by wire throttle setup. Plenums also available.

PLEASE NOTE - as with all after-market engine management systems, base maps are offered “as-is” and dyno tuning is highly recommended to avoid causing damage to your engine.

Free UK postage on all our products! We can ship this item worldwide (excluding North America) for £200.